The 8-channel NV-8PS13-PVD is a key hybrid component that consolidates all CCTV system cabling using standard EIA/TIA 568B structured building wiring. Designed for installation in the IDF/Telecom Closet or MDF/Equipment Room, the Power Supply Passive Video Receiver Hub has independently selectable 24VAC-OFF-28VAC outputs that can support at-distance camera loads up to 1 Amp per channel. Use with NVT’s PVD™ transceivers for cable runs under 225m (750ft). A built-in passive receiver hub allows connection to DVR or an encoder for IP transmission. Per-channel diagnostic LEDs display load /no-load, crosswires, or fault conditions at a glance. Automatic-reset fault protection, transient protection, and ground loop free individually floating outputs.

• Provides Class 2 SELV camera power while receiving video transmission and delivering P/T/Z telemetry all over a single 4-pair Cat5 (or better) cable
  
  
• Standard telecom/datacom structured cabling pinouts per EIA/TIA 568B
  
  
• Independently selectable 24VAC-OFF-28VAC with 1 Amp per channel
  
  
• Automatic-reset fault protection; transient protection
  
  
• Individually floating outputs ensure total ground-loop immunity
  
  
• Diagnostic LEDs show load/no load, crosswires, and overload conditions
  
  
• Use with the NV-216A-PV, NV-218A-PVD, or NV-226J-PV transceiver at the camera
  
  
• Power cameras via UTP over significant distances (see Power Distance Chart)
  
  
• 1U high; 20,32cm deep; wall, desk, or rack-mountable, 60cm (2ft) BNC Cables included
  
  
• Limited lifetime warranty